IncroMold^™ S

IncroMold™ S internal mold release additive is used to improve cycle time and productivity in polyolefins. It is suitable for use up to temperatures of around 270°C.

IncroMold™ S additive can be dispersed evenly through the polymer in the melt phase. It migrates to the surface of the polymer where it forms a thin lubricating layer. This layer reduces coefficient of friction between surfaces and reduces unwanted adhesion.

Guidelines for Use:

IncroMold™ S internal additive can be incorporated into resin as supplied or via masterbatch / pre-blend. Experience has shown that simple manual mixing prior to processing will normally give an acceptable dispersion, though mechanical means are preferred.

Typical addition levels are 0.2 - 0.5% for molding applications.

Key Specs